6602
Chevy/Dodge/Ford cross over steering drop pit man arm used in our crossover steering kits.
Fits 32 spline 4 relief Saginaw steering box's 2wd for 67-87 4x4 conversion (88-91 Suburban and Blazer solid axle factory trucks).
Fits 32 spline 4 relief Saginaw steering box's IFS 4x4 strait axle conversion 88-07 GMC/Chevy.
Pit man arm 6602 fits 78-79 F-100 through F-350 steering box's, whether facing forward or rearward. Will not have correct orientation on 80-newer Ford.
Fits Dodge, 6602 crossover steering conversion pit man arm used on leaf sprung power steering equipped 4x4 trucks and Ram Charger, years 73-92. Requires relocating steering box to 2wd location on Dodge vehicles. Use's Dodge/Chevy style tie rod ends. 4" drop. 32 spline 4 relief box must be used.
Reamed to fit a GM 1 ton tie rod end. Arms are measured from top of sector shaft mount to bottom of Tie rod end mount plane.
Forged steel.
We accept product returns within 30-days after you have received your order. All returns are subject up to a 20% restocking fee after approval.
Its the quality you expect from OBS Solutions.
Brackets were well made. One if the struts was dead out of the box, which isnt their fault. Called and had a replacement withing 3 days! Never any complaints dealing with these guys!
I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
I’ll be honest and say the product was great quality but I dont think ill use them! They’re kinda far out to the side and I almost feel like I don’t see anymore than I did with the smaller mirrors. I’ll keep them in case I go a different route but I ended up taking them off! I wish they came with a lower convex mirror like a newer duty does. That would help tremendously.
Very well made can't go wrong with obs.
This was a great upgrade for my 1995 F-150 (5.0 V8). I will make a note: there will be a spare negative cable. It's going to be the one that has "Body Frame" on one end, slightly longer than the negative that runs from the solenoid to the battery.
I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
Excellent quality, easy to install, get rid of your hood bending coil springs! Anything these guys make is top notch quality!
Very sturdy , really like the short tucked in design.
I feel they need to add some adhesive where some of the push clips are to shallow of a hole to hold in. But quality of this is awesome
Added these (2”) to my truck along with the superduty leaf spring shackles to level my truck to match the RSK kit in the front. Leveled it out nicely. With the boomerang shackles, shackle flip kit and superduty springs it lifted the rear of the truck about 2.5inches total.
