I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
1980-1997 Ford F-Series Rear Bed Step Kit
Cody Friday
Hood strut
Excellent quality, easy to install, get rid of your hood bending coil springs! Anything these guys make is top notch quality!
1980-1997 Hood Strut Kit
Aubrey Carroll
Very sturdy , really like the short tucked in design.
Standard Swing Lock Mirror Bracket
Cody Friday
Looks excellent
I feel they need to add some adhesive where some of the push clips are to shallow of a hole to hold in. But quality of this is awesome
Under Hood Cover
James E
Quality stuff
Added these (2”) to my truck along with the superduty leaf spring shackles to level my truck to match the RSK kit in the front. Leveled it out nicely. With the boomerang shackles, shackle flip kit and superduty springs it lifted the rear of the truck about 2.5inches total.
Its the quality you expect from OBS Solutions.
Brackets were well made. One if the struts was dead out of the box, which isnt their fault. Called and had a replacement withing 3 days! Never any complaints dealing with these guys!
I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
I’ll be honest and say the product was great quality but I dont think ill use them! They’re kinda far out to the side and I almost feel like I don’t see anymore than I did with the smaller mirrors. I’ll keep them in case I go a different route but I ended up taking them off! I wish they came with a lower convex mirror like a newer duty does. That would help tremendously.
This was a great upgrade for my 1995 F-150 (5.0 V8). I will make a note: there will be a spare negative cable. It's going to be the one that has "Body Frame" on one end, slightly longer than the negative that runs from the solenoid to the battery.
