We accept product returns within 30-days after you have received your order. All returns are subject up to a 20% restocking fee after approval.

FORD-FSSH-001-Raw
-Rear hanger for the front spring.
-Much stronger than the factory part.
-OEM Style is a direct replacement for the Ford factory bracket and 3-5" reversal shackles.
-Lo-Pro Style is designed to work with our 2" Shackle Reversal shackles only!
-Designed with forward mounting holes to help shackle angle with lift springs.
-Brackets are fixture welded at the correct offset to compensate for the factory frame angle. 1/4" laser cut PnO steel.
Sold as a pair
Application:
-Truck: 80-97 4wd Ford F250/350
Additional Information:
OEM Style brackets have a 9/16" hole in the stock location and another 1" forward. This replaces Ford-EOTZ-5340-A and -B. These are used in our 4" FSRSD kit.
Lo-Pro's have a hole 1" forward and 1" Up of factory, only to be used with our 2" shackles. These are used in our 2" FSRSD and FSROB-003 kits.
Offset Lo-Pros are offset to match the 37.5" spring pin center of the 99-04 Superduty Dana 60/50. These are used in our FSRSDAL and PNSDAL kits.
This provides a better angle of the shackle when used in a shackle reversal system helping release tension on the spring increasing ride quality even more than just the standard shackle reversal currently gains. Basically it adds to the angle of the shackle instead of a near vertical position. This kit will also help those who have aftermarket springs that are slightly shorter than the factory spring gain a decent shackle angle.
Remove factory rivets holding original bracket.
Pry the factory hanger from the frame.
Align the holes in the new hanger with the frame and die grind frame holes if needed to make perfect.
Please note they are not all in the same exact position on every vehicle and possibly will require mounting hole trimming.
Bolt on new hanger with supplied hardware or weld if desired.
We accept product returns within 30-days after you have received your order. All returns are subject up to a 20% restocking fee after approval.
Three of my AC and heat panel fasteners were broken out and I had installed a double DIN (7”x4”) Pioneer radio so this bracket needed modified to fit this large radio. I cut just above the angled horizontal bracket on each side. The radio fits fine and the bracket is robust enough without the horizontal support. OBSSolutions fabricates great parts and solves any systemic issues of these trucks so they can be made better than new.
Great kit, awesome customer service. Perfect upgrade from the old bench seats in my 88.
This step makes it easy for me to get into the bed of my 1995 F250 2wd. Instructions were easy to follow, 20 minutes start to finish!! Looks great and does what I want. Picked it up Friday at the NO BS OBS Truck Show. Thanks for organizing the show and for the terrific parts!
These steps look the best imo, and there's no denying the quality of the design and materials. They are extremely robust, and should last a lifetime, while also being very sturdy compared to the hoop steps. Cost is the only con, but I'm sure r&d plus fabrication wasn't cheap, and I'm happy supporting OBS Solutions!
Very impressed with these lights both in quality and ease of install. They’re WAY brighter than the old lights. They plug in to the original bulb socket perfectly. The instructions are easy to follow. Can’t say enough good about them!
I have been searching for my "front end" pop forever, after researching and figuring out this was my cause. Quality is great, easy install, and thankfully no more pop.
Replaced my old warn out and cracked tank. glad to have one that doesn't leak and I dont have to worry about anything falling into it.
Hard to find this kit yet they had it and got it to me quickly. Thank you