DM-15P011-01
The Transfer Case Skid Plate not only looks great, but it provides maximum ground clearance while protecting your vulnerable transfer case. This will also give your truck an extra structural crossmember between your frame rails. Engineered with laser cut 3/16" steel plate and 1.5" x .120 DOM tubing. It's stout tube and plate design protects your t-case on the one side, including drainage holes allowing water and debris to escape. The other side is open, allowing heat from your exhaust system to escape. The skid plate comes raw or powder coated semi-gloss black and locates in two factory holes on your frame rail. Just drill your other four holes and bolt it on using supplied hardware. Raw option is perfect for anyone looking for a base to build off of such as transmission mounts when doing engine swaps.
NOTE: Fits Broncos and F Series truck models with AOD, E4OD and BW1356 transfer cases, however it can be used for other applications given its bolt on design. If this transfer case skid plate is used on Standard cab Truck please note that the back two bolt holes don't contact the frame rail. Spacers will need to made if customer wants to use all 6 bolt holes.
Features:
We accept product returns within 30-days after you have received your order. All returns are subject up to a 20% restocking fee after approval.
I had to use 2" aluminum square stock to space this down cause I have a NV271 T-case swap in my 97. I got rubber square table ends to plug up the square stock ends. It looks pretty nice.
I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
Excellent quality, easy to install, get rid of your hood bending coil springs! Anything these guys make is top notch quality!
Very sturdy , really like the short tucked in design.
I feel they need to add some adhesive where some of the push clips are to shallow of a hole to hold in. But quality of this is awesome
Added these (2”) to my truck along with the superduty leaf spring shackles to level my truck to match the RSK kit in the front. Leveled it out nicely. With the boomerang shackles, shackle flip kit and superduty springs it lifted the rear of the truck about 2.5inches total.
Its the quality you expect from OBS Solutions.
Brackets were well made. One if the struts was dead out of the box, which isnt their fault. Called and had a replacement withing 3 days! Never any complaints dealing with these guys!
I was tired of going to the dump and having to jump up on the tail gate with my knees cause I’m to lazy to roll up my bed cover to use the tire as a step anyways this was super easy to put on and works / looks great my truck has a 8 inch lift with 38s
I’ll be honest and say the product was great quality but I dont think ill use them! They’re kinda far out to the side and I almost feel like I don’t see anymore than I did with the smaller mirrors. I’ll keep them in case I go a different route but I ended up taking them off! I wish they came with a lower convex mirror like a newer duty does. That would help tremendously.
Very well made can't go wrong with obs.
This was a great upgrade for my 1995 F-150 (5.0 V8). I will make a note: there will be a spare negative cable. It's going to be the one that has "Body Frame" on one end, slightly longer than the negative that runs from the solenoid to the battery.
